Trx/Ext Transceiver 1 (Trx1)-Transceiver 3 (Trx3) - Icom VE-PG2 Instruction Manual

SELECTIVE CALL MODE SETTING SCREEN
5-5 TRX/EXT Transceiver 1 (TRX1)–Transceiver 3 (TRX3)
ï Transceiver control setting
Set the details of the transceiver control for the [TRX1]–[TRX3] ports.
Place the mouse pointer on "Connection setting," and then on "TRX/EXT," and then
click on one of the Transceiver ports, TRX1, TRX2 or TRX3 shown on the list.
q
w
e
r
t
q Transceiver connection detector
Set the transceiver detection for each port to "Enable" or "Disable."
When "Disable" is set, some connections may cause the port's indicator to mistak-
enly light. Therefore we recommend you always use the default setting, "Enable."
(Default: Enable)
w Priority receive mode
Set the Priority receive mode to "Enable" or "Disable."
(Default: Disable)
• Disable : The VE-PG2 allows the VOX to switch the transceiver from receive to transmit, nor-
mally.
• Enable : While the transceiver is receiving a signal, the VE-PG2 keeps it in the receive mode,
even if the VOX circuit detects audio.
e Tx volume
Set the VE-PG2's transmitting audio level that is sent to the connected transceiver.
(Default: 0)
(Selectable range: –18 to +6 (dB), 1 dB steps)
r Rx volume
Set the VE-PG2's audio output level of the AF signal that is received from the con-
nected transceiver.
(Default: 0)
(Selectable range: –18 to +6 (dB), 1 dB steps)
t PTT cancel mode
Set cancel a call if the transceiver receives a transmit request while calling.
(Default: Disable)
5
1
2
3
4
5
6
7
8
9
10
11
183