Trx/Ext Transceiver 1 (Trx1)-Transceiver 3 (Trx3) - Icom VE-PG2 Instruction Manual

4
BRIDGE MODE SETTING SCREEN
■ Connection setting (Continued)
4-7 TRX/EXT Transceiver 1 (TRX1)–Transceiver 3 (TRX3)
ï Transceiver control setting
Set the transceiver control settings. The transceivers, connected to the [TRX1]–
[TRX3] ports, are controlled according to these settings.
Place the mouse pointer on "Connection setting," and then on "TRX/EXT," and then
click on one of the Transceiver ports, TRX1, TRX2 or TRX3 shown on the list.
q
w
e
r
t
y
q Transceiver connection detection
Set the transceiver detection for each port to "Enable" or "Disable."
When "Disable" is set, some connections may cause the port's indicator to mistak-
enly light. Therefore we recommend you always use the default setting, "Enable."
(Default: Enable)
w Audio transmission methods to the transceiver
Select either VOX or RTP as the audio sending type, for the connected transceiver
transmits the sent audio signal from the VE-PG2.
If intermittent audio occurs at while this items is set to "VOX," set it to "RTP."
(Default: VOX)
VOX: The VE-PG2 sends the audio signal to the connected transceiver when the
audio input level is exceeds the VE-PG2's VOX setting level.
RTP: The VE-PG2 sends the audio signal to the connected transceiver while the VE-
PG2 is receiving RTP packets.
[NOTE]
RTP (Real-time Transport Protocol) sends and receives the audio signals through
the IP network.
142