Icom VE-PG2 Instruction Manual page 203

SELECTIVE CALL MODE SETTING SCREEN
ï Broadcast setting
Set the details of the broadcast tone to output to the external device which is
connected to the [OUT] port of the VE-PG2.
Place the mouse pointer on "Connection setting," and then on "TRX/EXT," and then
click "EXT Output (EXT OUT)" shown on the list.
q
w
e
q Broadcast start tone
Set the tone type before the broadcast starts.
(Default: Single tone 1)
Selectable from Not use, 4 tone notice (up), Single tone 1 or Single tone 2.
w Broadcast end tone
Set the tone type after the broadcast ends.
(Default: Not use)
Selectable from Not use, 4 tone notice (down), Single tone 1 or Single tone 2.
e Notice tone volume
Set the notice tone volume level.
(Default: 0)
(Selectable range: –18 to +6 (dB), 1 dB steps)
5
1
2
3
4
5
6
7
8
9
10
11
203