Icom VE-PG2 Instruction Manual page 134

4
BRIDGE MODE SETTING SCREEN
■ Connection setting
4-4 IP network connection EXT Output (EXT OUT)
ï IP network connection setting (Continued)
Place the mouse pointer on "Connection setting," and then on "IP network
connection," and then click "EXT Input (EXT IN)" shown on the list.
q
w
e
r
• The above setting screen is only displayed when you set "IP communication mode setting" to
"Multicast mode." (p. 124)
• You cannot set these settings when "During receive" is displayed in the status field of "IP
network connection status."
• The default settings (q–r) are dependent on "IP communication mode setting."
r TTL
Set the maximum hop number to send the multicast packets.
If the multicast packets pass through the IP router, TTL decreases by 1.
When TTL becomes less than 0, the multicast packets are automatically deleted
from the IP network.
This item can be set only when the "Multicast mode" option is selected in "IP
communication mode setting" of EXT OUT.
(Default setting: 1)
(Selectable range: 1 to 255)
[NOTE]
If you set "IP communication mode setting" to "Unicast mode," the "IP network con-
nection setting" information is displayed as shown below.
134