Icom VE-PG2 Instruction Manual page 300

6
CONVERTER MODE SETTING SCREEN
■ Connection setting
6-15 Numbering plan (Continued)
ï Call destination number setting
Set each DTMF signal's connection destination for calls that are sent from a trans-
ceiver.
Place the mouse pointer on "Connection setting," and then click "Numbering plan"
shown on the list.
q
w
e
r
q Index:
Set the index number for the call destination.
(Default: 1)
w Call destination number:
Set the DTMF code to call the destination VE-PG2.
(Default: Blank)
e Call destination VE-PG2 address:
Set the destination VE-PG2's IP address.
(Default: Blank)
r Call destination VE-PG2 port:
Set the destination VE-PG2's connection port.
(Default: Transceiver 1 (TRX1))
300