Icom VE-PG2 Instruction Manual page 128

4
BRIDGE MODE SETTING SCREEN
■ Connection setting
4-2 IP network connection Transceiver 1 (TRX1)–Transceiver 3 (TRX3)
(Continued)
ï IP network connection status
The screen shows the status of the [TRX1]–[TRX3] ports' network connection, and
has controls for their connection.
Place the mouse pointer on "Connection setting," and then on "IP network connec-
tion," and then click on one of the Transceiver ports, TRX1, TRX2 or TRX3 shown on
the list.
• The [Reload] and [Connect]/[Disconnect] buttons will not selected in the Unicast mode if you
have not set "Connection IP address."
q Status
Displays ports [TRX1]–[TRX3] connection settings for the IP network.
• The VE-PG2 has 3 statuses ("Not connected," "During transmit," and "During receive").
w [Reload]
Click [Reload] to reload and display the current status of ports [TRX1]–[TRX3].
e [Connect]/[Disconnect]
Connect or disconnect to or from the [TRX1]–[TRX3] ports.
[NOTE]
• You can confirm the connection status on this screen.
• [VoIP] lights green while one of the [TRX1]–[TRX3] ports is connected to IP network.
• You can confirm the connection status of the [TRX1]–[TRX3] ports by looking at the [TRX1]–
[TRX3] indicators light on the VE-PG2, or by referring to "Information list for IP connection."
(p. 171)
128
q
w
e