Trx/Ext Ext Input (Ext In) - Icom VE-PG2 Instruction Manual

5
SELECTIVE CALL MODE SETTING SCREEN
■ Connection setting (Continued)

5-6 TRX/EXT EXT Input (EXT IN)

ï EXT voice terminal setting
Set the external equipment signal's input connection port, input AF signal's detec-
tion, etc. that input from the [IN] port, in this screen.
Place the mouse pointer on "Connection setting," and then on "TRX/EXT," and then
click "EXT Input (EXT IN)" shown on the list.
q
w
q Input connection port
Set the output port for an AF signal received from the [IN] port.
(Default: IP network)
• EXT Output: Sends it to the [OUT] port.
[NOTE]
This item is not selectable if you set "Combined mode" option in "EXT I/O port" on
"Operating mode."
• IP network: Sends it to the [LAN] port.
[NOTE]
If you set [IP network communication-EXT Input (EXT IN)] or [IP network communi-
cation-EXT I/O port (EXT)], the AF signal is sent to them at the same time.
• Emergency: Set the AF signal from the [IN] port to use for emergency communication.
[NOTE]
Sends the AF signal to the device which is selected in [Emergency notice setting]–
[Emergency notice].
• Also set [IP network communication–Emergency notice].
• Emergency communication has priority over normal communication.
w Valid timing
Set the input AF signal's detection settings.
(Default: Control data detection)
• Always-on connection: Always sends the AF signal to [Input connection port].
If you set "Emergency" in [Input connection port], you can not select this item.
• AF input detection: Sends the AF signal to [Input connection port] when an AF signal is de-
tected.
• Control data detection:Sends the AF signal to [Input connection port] when a control signal is
detected.
190