Installation And Connection ─────────9; 2-1.Installing On Mast - Icom SB-110 Instruction Manual

PDF取説-E_1 02.1.23 10:28 ページ10
2
INSTALLATION AND CONNECTION
2-1 Installing on Mast
When you install two SB-110 (the built-in antenna type), any obstruction must not be lo-
cated between those SB-110s.
* The installation with the elevation angle bracket (MB-89), an optional accessory, is
shown below as an example:
* When you use the elevation angle bracket (MB-89), if the mast diameter is small, the U bolt
which comes with SB-110 may contact the SB-110 depending on the adjustment angle.
When you fix SB-110, take care not to contact the U bolt to SB-110 considerably.
Upper: 30 degrees
Left: 30 degrees
Right: 30 degrees
■ How to Install Elevation Angle Bracket (Optional Accessory)
Remove a bracket from SB-110 and replace it with the elevation angle bracket (MB-89).
To lock this elevation angle bracket, use the screws for the original bracket.
10
SB-110
Flat washer
Wing nut S washer
Elevation Angle Bracket
(optional accessory)
SB-110
Elevation Angle Bracket
U Bolt
(optional accessory)
Mast clamp
Lower: 30 degrees
To lock the elevation angle
bracket, use these four screws
for the original bracket.
Mast