Icom VE-PG2 Instruction Manual page 265

i Calling notice tone to Transceiver
Set the notice tone to the transceiver when another transceiver is calling.
(Default: Notice tone2)
o Send connect success tone to Transceiver
Set the notice tone to the transceiver when the transceiver successfully connects to
another specified transceiver.
(Default: Notice tone2)
!0 Disconnect notice tone to Transceiver
Set the notice tone to the transceiver, when the VE-PG2 finishes the selective call
connection.
(Default: Notice tone3)
!1 Send connect failure tone to Transceiver
Set the notice tone to the transceiver, when the VE-PG2 cannot call the specified
transceiver.
(Default: Notice tone3)
!2 Transceiver notice tone volume
Set the notice tone volume level.
(Default: 0)
(Selectable range: –18 to +6 (dB), 1 dB steps)
!3 PTT controlled by VoIP telephone
Set either VOX or DTMF to control the connected transceiver's [PTT] switch.
(Default: VOX)
!4 PTT-ON tone
Select the DTMF code to turn ON the connected transceiver's [PTT] switch.
This item is displayed only when the "DTMF" option is selected in "PTT controlled by
VoIP telephone."
(Default: 0)
• 0–9, * or # are selectable.
!5 PTT-OFF tone
Select the DTMF code to turn OFF the connected transceiver's [PTT] switch.
This item is displayed only when the "DTMF" option is selected in "PTT controlled by
VoIP telephone."
(Default: 0)
• 0–9, * or # are selectable.
CONVERTER MODE SETTING SCREEN
6
1
2
3
4
5
6
7
8
9
10
11
265