Ignition Coil; Manifold Absolute Pressure/Inlet Air Temperature (Map/Iat) Sensor - Arctic Cat Wildcat ROV 2013 Service Manual

The 4-pin relays are identical plug-in type located on the power
distribution module. Relay function can be checked by switch-
ing relay positions. The 4-pin relays are interchangeable.
 NOTE: The module and wiring harness are not a service-
able component and must be replaced as an assembly.
1. Remove a fuse from the power distribution module.
2. Set the meter selector to the DC Voltage position.
3. Connect the black tester lead to ground.
4. Using the red tester lead, contact each end of the fuse
holder connector terminals individually.
5. The meter must show battery voltage from one side of
the connector terminal ends.
 NOTE: Battery voltage will be indicated from only
one side of the fuse holder connector terminal; the
other side will show no voltage.
 NOTE: When testing the HI fuse holder, the head-
light OFF/HI/LO switch must be in the HI position;
when testing the LIGHTS fuse holder, the headlight
dimmer switch can be in either the HI or LO position.
 NOTE: If the meter shows no battery voltage, trou-
bleshoot the battery, switches, power distribution
module, or the main wiring harness.
This vehicle uses automotive-style (see-through) fuses. The
fuses can be visually inspected; replace fuse if link is open.
CAUTION
Always replace a blown fuse with a fuse of the same
type and rating.
 NOTE: Make sure the fuses are returned to their proper
position according to amperage. Refer to the amperage
listed under each fuse on the power distribution module.

Ignition Coil

The ignition coils are mounted to the lower radiator frame
(rear cylinder) and the forward heat shield (front cylinder).
Remove the rear body panel and cargo box to access the coils.
VOLTAGE (Primary Coil)
1. Set the meter selector to the DC Voltage position; then
disconnect the connector from the coil to be tested.
2. Connect the red tester lead to the orange wire and the
black tester lead to ground.
132
3. Turn the ignition switch to the ON position. The meter
must show battery voltage.
RESISTANCE
Always disconnect the battery when performing resis-
tance tests to avoid damaging the multimeter.
 NOTE: For these tests, the meter selector should be
set to the OHMS position.
Primary Winding
1. Disconnect the primary connector and connect the red
tester lead to one terminal; then connect the black tes-
ter lead to the other terminal.
2. The meter reading must be within specification.
Secondary Winding
1. Connect the red tester lead to the high tension lead
(with the plug cap removed); then connect the black
tester lead to either primary terminal.
2. The meter reading must be within specification.
 NOTE: If the meter does not show as specified,
replace ignition coil.
Spark Plug Cap
1. Connect the red tester lead to one end of the cap; then
connect the black tester lead to the other end of the cap.
2411-883
2. The meter reading must be within specification.
 NOTE: If the meter does not show as specified,
replace the spark plug cap.
Manifold Absolute
Pressure/Inlet Air
Temperature (MAP/IAT)
 NOTE: Preliminary checks may be performed on this
component using the diagnostic mode on the LCD
gauge (see EFI Diagnostic System in this section).
1. Disconnect the MAP/IAT connector from the sensor
located on top of the throttle body.
CAUTION
Sensor
AR603D