Dell C7765dn User Manual page 611

Status Code
003-751
[Cause]
[Remedy] Increase the resolution or scan area.
003-752
[Cause]
[Remedy] Set [Resolution] to [400 dpi] or lower, and try scanning again.
003-753
[Cause]
[Remedy] Set [Resolution] to [200 dpi], and scan the document again.
003-754
[Cause]
003-755
[Remedy] Execute the job again.
003-756
[Cause]
[Remedy] Check whether the document is blank or whether the side of the document to be faxed
003-757
[Cause]
[Remedy] Set [Resolution] to [300 dpi] or lower, and scan the document again.
003-760
[Cause]
[Remedy] Confirm the selected options.
003-761
[Cause]
[Remedy] Change the paper size for the tray, or change the [Paper Type Priority] settings.
003-763
[Cause]
[Remedy] Place the Calibration Chart correctly on the document glass.
Refer to "Executing Calibration" (P.265).
003-780
[Cause]
[Remedy] Reduce the resolution or the ratio for [Reduce / Enlarge] to decrease the data size, or
003-795
[Cause]
[Remedy] Take one of the following measures:
005-275
[Cause]
005-280
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
010-330
[Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
Unable to process the document because the specified scan area is too small.
A mix sized document was to be scanned at 600 dpi in Color/2 sided.
A mix sized document was to be scanned at high resolution, 2 sided.
An error occurred in the document feeder.
The faxed document is completely blank.
is loaded correctly.
A mix sized document was to be scanned at high resolution, 2 sided.
An incompatible combination of feature is specified for document scan conditions.
The paper size of the tray selected for auto tray differs from the paper size of the tray
selected for Auto Paper selection.
An error occurred when reading the Calibration Chart.
Failed to compress the scanned document.
split the data to send it separately.
When enlarging/reducing a scanned document to the paper size specified, the
reduction/enlargement ratio exceeds the allowed range.
• Manually enter a reduction/enlargement ratio.
• Change the paper size.
An error occurred in the document feeder.
on the machine power. If the error still is not resolved, contact Customer Support at
dell.com/contactdell.
An error occurred in the machine.
on the machine power. If the error still is not resolved, contact Customer Support at
dell.com/contactdell.
Cause and Remedy
Status Code
611