Other Errors - Dell C7765dn User Manual

23 Problem Solving
Status Code
133-710
[Cause]
[Remedy] Take one of the following measures:
149-310
[Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
149-700
[Cause]
[Remedy] Check whether the specified paper is supported by the machine.
Note

Other Errors

This section describes the remedies when the following messages are displayed.
Error
Message
A fault has occurred.
Switch off the machine.
(xxx-yyy)
Completed with an
error.
(xxx-yyy)
A fault has occurred.
The machine has
rebooted. Select
[Close]. If the problem
persists, call for service.
(xxx-yyy)
680
When printing the received fax document, the paper loaded on the bypass tray was used
for printing because the specified tray could not be used.
• Load paper available for printing the received fax document:
A3 SEF , A4 LEF , B4 SEF
A4 SEF , A5 SEF
8.5 x 13" SEF , 8.5 x 14" SEF
8.5 x 11" LEF , 5.5 x 8.5" SEF
• Use a paper type available for printing the received fax document:
plain paper, bond paper, recycled paper, side 2 paper, user-defined custom paper.
• Confirm the settings by selecting [Tools] > [System Settings] > [Fax Service
Settings] > [Fax Control] > [Receiving Paper Size].
1)Select [Receiving Paper Size] > [Tray Mode] to add a tray to be used for printing the
received fax documents.
2)Set up paper so that the tray specified for [Tray Mode] can be used for printing the
received fax documents.
If the error still is not resolved, contact Customer Support at dell.com/contactdell.
The machine was turned off during the downloading.
on the machine power. If the same message is displayed again, contact Customer
Support at dell.com/contactdell.
The output destination was changed to the Finisher Output Tray although you selected
the High Capacity Stacker.
• If you cannot resolve an error despite following the instructions described in the table, contact
Customer Support at dell.com/contactdell.
[Cause] An error occurred.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and
then switch the machine power on again.
If the message persists, record the content displayed for [(xxx-yyy)]. Then
immediately switch the main power and power off, make sure that the touch
screen is blank, and then contact Customer Support at dell.com/contactdell.
[Cause] An error occurred, and the operation terminated abnormally.
[Remedy] Execute the operation again.
[Cause] An auto-recoverable internal error occurred, and the machine restarted
automatically.
[Remedy] Select [Close] to use the machine normally. If the error still is not resolved,
contact Customer Support at dell.com/contactdell.
Cause and Remedy
, B5 LEF ,
, B5 SEF , 8.5 x 11" SEF
, 11 x 17" SEF
.
Cause and Remedy
,
,