Dell C7765dn User Manual page 646

23 Problem Solving
Status Code
024-742
[Cause]
[Remedy] Change the printer properties setting to split the pages appropriately to create separate
024-746
[Cause]
[Remedy] Confirm the print data.
024-747
[Cause]
[Remedy] Confirm the print data, and try printing again.
024-748
[Cause]
[Remedy] Set [Bates Stamp - Number of Digits] to the value specified in [Starting Number] or to
024-775
[Cause]
[Remedy] Change the printer properties setting to split the pages appropriately to create separate
025-596
[Cause]
025-597
[Remedy] Replace the hard disk.
026-400
[Cause]
[Remedy] Disconnect the third or more devices so that the number of connected devices becomes
026-700
[Cause]
[Remedy] Execute the operation again. If the error still is not resolved, contact Customer Support
026-701
[Cause]
[Remedy] Wait for a while and execute the operation again. If the only one query is being
026-702
[Cause]
[Remedy] Wait for a while and execute the operation again. If the error still is not resolved, contact
026-703
[Cause]
[Remedy] Authenticate when adding documents.
646
Booklet printing was specified for printer properties, but the number of print pages for
the job exceeded the maximum number allowed for booklet creation.
volumes, or to cancel the booklet creation setting.
The specified paper type is not compatible with the specified paper size, paper tray,
output tray, or 2 sided printing.
Incompatible print parameters are used. The combination of the specified features such
as Document Size, Paper Size, Paper Tray, 2 sided printing, and Output Tray is
incompatible.
The number of digits specified in [Bates Stamp - Number of Digits] screen does not
match the value specified in [Starting Number].
[Auto Assign].
Booklet printing was specified for printer properties, but the number of print pages for
the job exceeded the maximum number allowed for booklet creation.
volumes, or to cancel the booklet creation setting.
An error occurred with the hard disk.
More than two devices are connected to the USB host port.
two. If the error still is not resolved, switch off the machine power, make sure that the
touch screen is blank, and then switch on the machine power.
By Address Book operation, the machine received an unsupported protocol from the
LDAP server.
at dell.com/contactdell.
The number of queries submitted to the Address Book exceeded the machine's
processing capability.
submitted to the Address Book, the machine's software may be defective. Contact
Customer Support at dell.com/contactdell.
The number of accesses from the LDAP server to the machine by Address Book
operation exceeded the machine's processing capability.
Customer Support at dell.com/contactdell.
Authentication is canceled when adding documents during faxing or scanning.
Cause and Remedy