Dell C7765dn User Manual page 624

23 Problem Solving
Status Code
016-718
[Cause]
[Remedy] Reduce the resolution, or cancel 2 sided printing or N up feature, and then print again.
016-719
[Cause]
[Remedy] Increase the size of the print page buffer.
016-720
[Cause]
[Remedy] Confirm the print data and try printing again.
016-721
[Cause]
[Remedy] For 1), when printing by the Auto Paper selection, set one of the paper types to other
Refer to "Paper Type Priority" (P.323).
016-722
[Cause]
[Remedy] Confirm the staple position and the paper size, and try printing again.
016-723
[Cause]
[Remedy] Confirm the punch position and the paper size, and try printing again.
016-724
[Cause]
[Remedy] Specify the staple and punch positions on the same side, and try printing again.
016-725
[Cause]
[Remedy] Do not use the Job Flow feature. Simply scan the document from the machine's [Fax]
016-727
[Cause]
[Remedy] The file could not be stored into the folder because the machine determined the print
016-728
[Cause]
[Remedy] Confirm the print data.
016-729
[Cause]
[Remedy] Change the number of colors or resolution for the TIFF file, and execute the operation
016-731
[Cause]
[Remedy] Retry printing.
016-732
[Cause]
[Remedy] Resend the form data.
624
Unable to process the PCL print data because of insufficient memory.
Unable to process the PCL print data because of insufficient print page buffer.
An invalid command is included in PCL print data.
An error occurred during print processing. Probable causes are as follows:
1)Printing was instructed by the Auto Paper selection when [Paper Type Priority] is set
to [Auto Paper Off] for all paper in the [Common Service Settings].
2)ESC/P-K command error occurred.
than [Auto Paper Off] in [Paper Type Priority].
For 2), confirm the print data.
The specified staple position is not supported by the machine, or the paper size specified
is not supported by the finisher.
The specified punch position is not supported by the machine, or the paper size
specified is not supported by the finisher.
The specified staple and punch position combination is unsupported.
A scanned document stored in a folder was to be sent by fax using the Job Flow feature,
but the file in the folder could not be converted to fax data.
screen to send it by fax.
A print job was cancelled without storing a file into a folder because the file was
determined as not containing any pages.
file as not containing any pages. Disable [Skip Blank Pages] on the [Advanced] tab on
the print driver, or add text to the file if the file is blank.
An unsupported tag is included in the TIFF file.
Unable to print because the number of colors or the resolution of the TIFF file exceeds
the allowed range.
again.
Unable to print TIFF data because it was interrupted.
The form specified by emulation has not been registered at the host side.
Cause and Remedy