Dell C7765dn User Manual page 673

Status Code
116-390
[Cause]
[Remedy] Follow the message displayed on the touch screen and initialize the memory of the
116-391
[Cause]
116-392
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
116-393
116-394
116-395
116-396
116-397
116-399
116-702
[Cause]
[Remedy] Check the print data.
116-703
[Cause]
[Remedy] For 1), check the print data.
116-704
[Cause]
[Remedy] Check whether the media is inserted correctly.
116-705
[Cause]
116-706
[Remedy] Use a computer to confirm the content recorded on the media.
116-707
116-708
116-709
116-710
[Cause]
[Remedy] Increase the size assigned to HP-GL/2 auto layout memory.
116-713
[Cause]
[Remedy] Delete unnecessary data from the hard disk to free up disk space.
116-714
[Cause]
[Remedy] Check the print data.
116-716
[Cause]
116-717
[Remedy] On a computer, confirm the content recorded on the media.
116-720
[Cause]
[Remedy] Stop unnecessary ports or delete unnecessary data to free up disk space.
116-738
[Cause]
[Remedy] Match the size and orientation of the paper with the form specified, and print again.
116-739
[Cause]
[Remedy] Delete unnecessary data, or free up the space for the form memory.
An error occurred in the machine.
machine.
An error occurred in the machine.
on the machine power. If the same message is displayed again, contact Customer
Support at dell.com/contactdell.
A print job was processed using a substitute font.
Probable causes are as follows:
1)An error occurred during PostScript processing.
2)An error occurred because of insufficient memory for PostScript processing.
For 2), increase the value for [PostScript Memory].
An error occurred when reading data on the media.
An error occurred when reading data on the media.
The correct document size could not be judged because the receive data exceeded the
HP-GL/2 spool size.
The data has been divided into a number of jobs because of insufficient disk space.
An HP-GL/2 command error occurred.
An error occurred when reading the data on the media.
An error occurred during print processing because of insufficient memory.
The size and orientation of the form specified are not matched with the paper to be
printed.
The form or logo data cannot be registered because memory for the form and logo data
or memory capacity for the hard disk is insufficient.
Cause and Remedy
Status Code
673