Network Command - Fujitsu FX-3001SR User Manual

4.1.4
Overview
Syntax
Parameter(s)
4
Password required?
1.
2.
If the Dip switch is set to use a DHCP server and the network command is
executed without any parameters, the IP address, subnet mask, and default
gateway assigned by the DHCP server are also displayed.
SERVIS IP-Serial
56
1p Converter
User's Guide

network Command

Displays/sets the current network information of product.
network <ipaddress> <subnetmask> <gateway>
network [-I | -m | -g ] [name]
None = Displays current network settings.
ipaddress = Specifies the IP address.
subnetmask = Specifies the subnet mask.
gateway = Specifies the default gateway.
-I = Only sets the IP address. Specify the IP addres to
Name.
-m = Only sets the subnet mask. Specify the subnet
mask to Name
-g = Only sets the default gateway. Specify the default
gateway to Name.
Notes
(1) Unless the system is restarted, the changes made by the network
command are not reflected.
Example (from the local console)
The following example sets the IP address to "192.168.0.50", the subnet
mask to "255.255.255.0", and the default gateway to "192.168.0.1".
Enter the network command.
$ network 192.168.0.50 255.255.255.0 192.168.0.1
ip address setting completed.
subnet mask setting completed.
default gateway setting completed.
$
Execute the reboot command to restart the product. Rebooting is required
in order to apply the settings.
Refer to 4.1.2 reboot Command (page 54)
No
Enter