Table of Contents
Advertisement
The output message that appears on the local console can be set to also be
displayed on the target port.
Output message to Local and Target Port? [Y/N] >
Select N to display the test message to the local port only.
Select Y to display the test message to both the local and target ports.
(2) Test results
The SDRAM control registers and test results are displayed as shown below.
SDRAM Control Registers
SDCTL0
0x00221000:81128300
SDCTL1
0x00221004:81128300
MISCELLANEOUS 0x00221014:00000000
SDRST
0x00221018:00000000
Check SDRAM0
Zero clear test
Test 0x08000000 - 0x09FFFFFF
write 0x00000000 ...
verify ... success
0x00,0xFF,0xAA,0x55 test
Test 0x08000000 - 0x09FFFFFF
write 0x00000000 ...
verify ... success
Test 0x08000000 - 0x09FFFFFF
write 0xFFFFFFFF ...
verify ... success
Test 0x08000000 - 0x09FFFFFF
write 0xAAAAAAAA ...
verify ... success
Test 0x08000000 - 0x09FFFFFF
write 0x55555555 ...
verify ... success
SDRAM0 check done.
Error messages
If a verification error occurs after writing to the SDRAM, an error message is
displayed.
The SDRAM address of the error, written data, and read data are displayed.
Example
verify error !
Address:0x08580380 write data:0x00000000 read data:0x00800000
SERVIS IP-Serial
165
1p Converter
User's Guide
7
Advertisement
Table of Contents
