Connection To Network - Fujitsu IP-900E Hardware User's Manual

2.4
2.4
To connect IP-900E/IP-900D/IP-900IID to a LAN device, connect the LAN device to the LAN
communication port of IP-900E/IP-900D/IP-900IID using a LAN cable (UTP cable). The LAN
communication port specification of IP-900E/IP-900D/IP-900IID is 10BASE-T/100BASE-TX.
The figure below shows the connection method.
For details about connectors and cables, see Section 4.2, "Cable and Connector Details."
NOTE:
For electrical specifications, see Appendix 2.3, "Function Specifications."
Please do not provision the IP address below.
・ IP address commonly unused（0.0.0.0，255.255.255.255，etc...）
・ Loop back address (127.xxx.xxx.xxx)
・ Class D and Class E addresses
・ IP address already used
For more information, see IP-900E/IP-900D/IP-900IID Software User's Guide.

Connection to Network

100-240V
FG
Figure Connection to a network
10/100BASE RS-232C
E
100M
PWR ALM OPT
LINK
RDY IN
/ACT
DWN
MNT
Hub, Router, PC, etc.
CAUTION
41
Chapter 2 Installation and Connection
L R
ANALOG AUDIO IN
IP-900E/IP-900D/IP-900IID