Fujitsu FX-3001SR User Manual page 15

Using an RJ45−D-Sub conversion adapter (9-pin or 25-pin), which is sold
separately, it can be modified to a D-Sub connector via this port and a CAT
straight cable.
Therefore, this product can be connected to types that have RJ45 sockets (Sun
products and CISCO products) or types that have a D-Sub (most devices).
Available conversion adapters
FP-AD009RJ
FP-AD025RJ
FP-AD009RJX (one included with this product)
FP-AD025RJX (one included with this product)
(3) Local console port
This port is connected to a console terminal to perform the boot check, settings,
and shutdown check of the product.
This can be connected to a PC by combining FP-AD009RJ (optional) with a
Cat5 cable. A PC can also be used as a console terminal by executing the
console terminal emulator on the PC.
(4) Power jack
Connects the power adapter. Do not use any power adapter other than the one
included with the product.
(5) Adapter holding clamp
A clamp for holding in the power adapter cable. Use this to prevent the power
adapter from unplugging.
An adapter that establishes an RS-232C cross cable that
combines the target port and a Cat5 straight cable. The
D-Sub side has a 9-pin female.
There may be cross wiring on the side of the device
connected to the target port. If that is the case, use
FP-AD009RJX.
The same as the FP-AD009J, but with a 25-pin male on
the D-Sub side.
An adapter that establishes an RS-232C cross cable that
combines the local console port and a Cat5 straight
cable. The D-Sub side has a 9-pin female.
The same as the FP-AD009RJX, but with a 25-pin male
on the D-Sub side.
SERVIS IP-Serial
5
1p Converter
User's Guide
1