Ntp Command; Servis Ip-Serial - Fujitsu FX-3001SR User Manual

4.1.10

ntp Command

Overview
Syntax
Parameter(s)
Password required?
Notes
(1) When executing ntpd, set the date and time in advance using the time
command. When the configured date and time vary greatly from the
time on the time server, the time cannot be obtained.
(2) Rebooting is required in order to apply the settings. Use the reboot
command to restart the system after changing the settings. By default,
ntpd is set to OFF.
(3) If ntpd is not specified, the current ntpd setting is used.
(4) The server name has a limit of 63 characters.
Example (from the local console)
Starts ntpd.
$ ntp -o 192.168.0.100
ntp setting on.
$
Displays the current NTP setting.
$ ntp
Enter↵
<ntp> on
192.168.0.100
$
Stops ntpd.
$ ntp -f
Enter
ntp setting off.
$
Sets the start/stop of ntpd and specifies the NTP server.
ntp [-o | -f] [server name]
None = Displays the current settings.
-o = Starts the ntpd.
-f = Stops the ntpd.
server name = Specifies the NTP sever.
No
Enter

SERVIS IP-Serial

63
1p Converter
User's Guide
4