Dip Switch Settings; Emulator Application Settings - Fujitsu FX-3001SR User Manual

2.2. DIP Switch Settings

Set the DIP switches in the front of the product according to your network environment,
2
IP address setting method (manual/DHCP), and startup operation (internal flash
ROM/CF).
Refer to
The following explanation uses the product setting scenario below as an example.
After changing the DIP switches, press the RESET button of the product.
Rebooting is required in order to apply the settings.

2.3. Emulator Application Settings

1. Power on the terminal device (local console), and then start the emulator
application (e.g. TeraTerm).
2. Configure the parameters of the emulator application. The following shows the
default parameters:
SERVIS IP-Serial
16
1p Converter
User's Guide
1.1.1 Front (page 2)
Manual IP address setting → DIP switch 4 OFF
Communication mode: Auto-negotiation → DIP switch 7 ON
Normal startup with only IPv4 → DIP switches 1, 2, 8 OFF
1 2 3 4 5
indicates a switch.
Protocol
Baud rate
Data length
Parity
Stop bit
Flow control
Emulation
6 7 8
On
Value
115200 bps
8 bits
None
1 bit
None
VT100 compatible terminal