2.5. Login via the Local Console
By default, only the administrative level user account "admin" is registered.
2
The following are the procedures for logging in as the admin user:
1.
Once the system starts up and the "login:" prompt is displayed, enter the user
name "admin".
login: admin
2.
When the "Password:" prompt is displayed, enter "admin", which is the default
password. The password is not displayed to the screen.
Password:
3.
Once logged in, the shell console, which is the user interface for system
configuration, is launched. In the shell console environment, commands can be
entered after the prompt shown below. These commands are used to configure
various settings of this product.
The name of the device being configured is displayed within the ().
$
4.
If the user name or password is incorrect, the following message is displayed
and you cannot log in. When the "login:" prompt is redisplayed, enter the user
name and password.
Login incorrect
login:
At the time of purchase of this product, the default administrator password is
enabled.
To ensure security, reset the administrator password before using the product.
SERVIS IP-Serial
18
1p Converter
User's Guide
Enter
Enter
Refer to
4.1 Shell Console Commands (page 52)