Self-Diagnostic Program - Fujitsu FX-3001SR User Manual

7.2. Self-diagnostic Program

Function overview
This is a mode to discover the cause when an error occurs while operating this
product.
Starting and exiting
1. Set DIP switch 1 on the front panel of this product to ON and restart.
1 2
indicates a switch.
2. When the self-diagnostic program is started, the following menu is displayed.
system diag mode
-----------------
1: Data R/W test
2: Hardware test
3: EXIT
select >
Select menu number 1 to perform a read/write test on peripheral devices or bus
integrity.
Select menu number 2 to perform a test on DIP switches, buttons, or LEDs.
Detailed descriptions can be found in the following sections.
To exit the self-diagnostic program, select 3: EXIT from the main menu.
system diag mode
-----------------
1: Data R/W test
2: Hardware test
3: Exit
select > 3
Enter
Bye...
Alternatively, the device may be turned off to exit the self-diagnostic program.
3 4 5 6 7
Rev1.00.00xx
Rev1.00.00xx
8
On
SERVIS IP-Serial
1p Converter
User's Guide
7
163