7.4. Updating the firmware
The following describes how to write a binary image on the flash ROM in order to
update this product's firmware.
Execute the writeflash command to write the image file on the flash ROM.
4.1.25 writeflash Command (page 79)
Refer to
Procedure
1.
Prepare a binary image in the CF card or NFS in advance, log in to this product,
and execute the writeflash command in the shell console.
While the binary image is being written, the status LED blinks orange.
The LED lights green and writing is finished when control returns to the shell
console.
(Example: the binary image "std-kernel4-1.00.0387" in the NFS is being written)
$ writeflash /mnt/fcl_bin/std-kernel4-1.00.0387
$
2.
If writing another binary image, execute the writeflash command in the same
way.
3.
After all of the binary images have been written, rebooting is required. Press the
RESET button.
The firmware update is finished.
Contact us for details on obtaining binary images.
The product takes longer than usual to start up immediately after firmware update is
finished.
Enter
SERVIS IP-Serial
1p Converter
User's Guide
7
183