Connection To Network - Fujitsu IP-920 E/DC Hardware User's Manual

Chapter 2 Installation and Connection
2.4
2.4
To connect IP-920E/DC to a LAN device, connect the LAN device to the LAN communication port
of IP-920E/DC using a LAN cable (UTP cable). The LAN communication port specification of
IP-920E/DC is 10BASE-T/100BASE-TX.
The figure below shows the connection method.
For details about connectors and cables, see Section 4.2, "Cable and Connector Details."
NOTE:
For electrical specifications, see Appendix 2.3, "Function Specifications."
12 - 24V
Please do not provision the IP address below.
・ IP address commonly unused（0.0.0.0，255.255.255.255，etc...）
・ Loop back address (127.xxx.xxx.xxx)
・ Class D and Class E addresses
・ IP address already used
For more information, see IP-920E/DC Software User's Guide.
IP-920E/DC

Connection to Network

PWR ALM
FG
Hub, Router, PC, etc.
Figure Connection to a network
CAUTION
10/100BASE
E
100M
OPT
LINK
IN
RDY
/ACT
DWN
MNT
36
RS-232C
ANALOG AUDIO IN