5.1.6.1 set target port
Overview
Menu location
Command
Output
5
SERVIS IP-Serial
138
1p Converter
User's Guide
Sets the serial port. If no value is entered and the Enter key is
pressed, the current setting remains.
MAIN MENU → 6. serial → 1. set target port
port
Refer to
--- 6. SERIAL MENU --------
1. set target port
2. set redirect [OFF]
3. set local console
4. set VT100
5. set port number
0. return to MAIN MENU
---------------------------
select > 1
Enter↵
<set target port>
baud rate [300,1200,1800,2400,4800,9600,14400,
19200,28800,38400,57600,115200]
change [9600] to : 115200
<set character size>
size [7:7bit, 8:8bit]
change [8] to :
Enter↵
<set parity bit>
parity [0:none, 1:odd, 2:even]
change [0] to :
Enter↵
<set stop bit>
stop [1:1bit, 2:2bit]
change [1] to :
Enter↵
<set flow>
flow [n:none, h:hardware, x:xon/xoff]
change [n] to :
Enter↵
target port setting completed.
--- 6. SERIAL MENU --------
1. set target port
2. set redirect [OFF]
3. set local console
4. set VT100
5. set port number
0. return to MAIN MENU
---------------------------
select >
Notes
(1) Settings for xon and xoff are from "00" to "ff".
(2) If the entered value does not match one of the choices, an error
message will be displayed for that option.
(3) If Enter is pressed in a blank space, the current setting remains.
4.1.17 port Command (page 70)
Enter↵