To do...
Configure the
current switch to be
an HABP server
Configure the
interval to send
HABP request
packets.
HABP Client Configuration
HABP clients reside on switches attached to HABP servers. After you enable HABP for a
switch, the switch operates as an HABP client by default. So you only need to enable HABP
on a switch to make it an HABP client.
Follow these steps to configure an HABP client:
To do...
Enter system view
Enable HABP
Displaying and Maintaining HABP Configuration
To do...
Display HABP configuration
and status
Display the MAC address
table maintained by HABP
Display statistics on HABP
packets
Use the command...
habp server vlan vlan-id
habp timer interval
Use the command...
system-view
habp enable
Use the command...
display habp
display habp table
display habp traffic
3-2
Remarks
Required
By default, a switch operates as an
HABP client after you enable HABP
on the switch. If you want to use the
switch as a management switch,
you need to configure the switch to
be an HABP server.
Optional
The default interval for an HABP
server to send HABP request
packets is 20 seconds.
Remarks
—
Optional
HABP is enabled by default. And a
switch operates as an HABP client
after you enable HABP for it.
Available in any view
Available in any view
Available in any view
Remarks