Irf-Port-Configuration Active - H3C S6812 Series Command Reference Manual

Examples
# Configure a port-specific load sharing mode for IRF-port 1/1 to distribute traffic based on
destination MAC address.
<Sysname> system-view
[Sysname] irf-port 1/1
[Sysname-irf-port1/1] irf-port load-sharing mode destination-mac
Related commands
irf-port global load-sharing mode

irf-port-configuration active

Use irf-port-configuration active to activate IRF ports.
Syntax
irf-port-configuration active
Views
System view
Predefined user roles
network-admin
Usage guidelines
After connecting the physical interfaces between two devices and binding them to the correct IRF
ports, you must use this command to activate the settings on the IRF ports. This command merges
the two devices into one IRF fabric.
The system activates the IRF port settings automatically in the following situations:
•
The configuration file that the device starts with contains IRF port bindings.
•
You are binding physical interfaces to an IRF port after an IRF fabric is formed.
Examples
To configure and activate IRF-port 1/2 when the port is in DIS state:
# Bind Ten-GigabitEthernet 1/0/1 to IRF-port 1/2.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] shutdown
[Sysname-Ten-GigabitEthernet1/0/1] quit
[Sysname] irf-port 1/2
[Sysname-irf-port1/2] port group interface Ten-GigabitEthernet 1/0/1
You must perform the following tasks for a successful IRF setup:
Save the configuration after completing IRF configuration.
Execute the "irf-port-configuration active" command to activate the IRF ports.
[Sysname-irf-port1/2] quit
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] undo shutdown
[Sysname-Ten-GigabitEthernet1/0/1] quit
# Save the configuration so the IRF port settings can take effect after the device reboots.
[Sysname] save
The current configuration will be written to the device. Are you sure? [Y/N]:y
19