Setting Extra Rs-232C Options - NCR 7167 Owner's Manual

7167 Owner's Manual
Switch Settings
The DIP switches are located on the PC board at the back of the printer as shown in the
illustration in "Level 1 Diagnostics" in chapter 4. The switches are used to put the printer
into various modes for printer configuration set up.
Use a paper clip or other pointed object to set the switches.
1. Set the switches to the desired settings shown in the table.
2. Reset the printer.
Caution: Setting switch 1 to On puts the printer in level 1 diagnostics (setup mode) where
other functions and tests can be changed.
DIP Switch Settings for RS-232C Parameters
Switch 1
Setting
OFF (0)
ON(1)
OFF (0)
ON (1)

Setting Extra RS-232C Options

The following extra options are available for the RS-232C Interface:
Data errors
Switch 2 Setting
OFF (0)
OFF (0)
ON (1)
ON (1)
•
Print "?" for data errors (default)
•
Ignore data errors
Printer State
On-line Mode (default)
Diagnostic Mode
Flash Download Mode
Vendor Adjustment Mode
November 2002
Chapter 5: Communication
78