Setting Switches; Printer Reset - NCR 7167 Owner's Manual

7167 Owner's Manual

Setting Switches

The DIP switches, located at the back of the printer, are used for three purposes:
•
To set variables for several printer functions (see the sections for the various
printer functions in "Level 1 Diagnostics" in "Chapter 4: Diagnostics" for Setting
Up The Printer)
•
To perform diagnostic tests (see the sections for the various diagnostic tests in
"Level 1 Diagnostics" in "Chapter 4: Diagnostics" for Setting Up The Printer)
Caution: The DIP switches are set to OFF.
Back of Printer
Bottom
Cover
Note: Switch 1 is shown in the Off position for reference.
Use a paper clip or other pointed object to set the switches.
1. Set the switches to the desired settings shown in the table.
2. Reset the printer.

Printer Reset

The printer is reset by disconnecting/reconnecting the DC power or by opening the
slip door and closing the slip door while holding the receipt paper feed button down.
DIP Switch Settings
Chapter 2: Setting Up and Using the Printer
DIP Switch
2 1 ON
Switch 1 is shown in
the OFF position
November 2002 13