NCR 7167 Owner's Manual page 124

7167 Owner's Manual
Select or Cancel Parallel Printing Mode on Receipt and Journal
Hexadecimal:
Because there is no journal station on the printer this command is not implemented and is
ignored if received. The command and its supporting operands will be discaraded.
Select Slip Station
Hexadecimal:
Selects the Slip Station for all functions. The receipt station is the default setting after the
printer is initialized or the Clear Printer (0x10) command is received. The Hex command:
1B 63 30 n , where n = 4 will also select the slip station.
Example:
MSComm1.Output = Chr$(&H1C)
Exceptions:
This command is ignored if Asian mode is On by diagnostic setting.
Select Cut Mode and Cut Paper
Hexadecimal:
102
ASCII: ESC z n
1B 7A n
27 122 n
Decimal:
ASCII: FS
1C
Decimal: 28
ASCII: GS V m
1D 56 m
Decimal: 29 86 m
Value of m: Selects the mode as shown in the table
Value of n : Determines cutting position only if m is 65 or 66.
or GS V m n
or 1D 56 m n
or 29 86 m n
November 2002
Chapter 6: Commands