NCR 7167 Owner's Manual page 76

7167 Owner's Manual
Check Flip Test Mode
To run the Check Flip Test Mode:
1. Enable the Check Flip Test Mode through the Configuration Menu (See "Configuring
2. Insert a check as if validating the check, lengthwise and face down into the slip
3. Push Paper Feed Button.
4.
To exit the Check Flip Test Model:
1. Enter the Configuration Menu again.
2. Disable the Check Flip Test Mode.
3. Exit the Configuration Menu
Print Head Gap Adjustment Mode
Print Head Gap Adjustment Test Mode prints several lines of 'H' character. This is the slip
print testing during the print head gap adjustment. During adjustment, some covers will
be removed from the printer, even in this condition, slip printing need to be run when
paper is inserted. Print Head Gap Adjustment Test Mode is enabled and disabled using
the Configuration Menu.
To run the Print Head Gap Adjustment Test Mode:
1. Enable the Print Head Gap Test Mode through the Configuration Menu, ("See
2. Insert a slip into the slip station.
the Printer," for instruction on how to enter the Configuration Menu), then exit the
Configuration Menu.
station. (See "Verifying and Validating Checks" section to insert check.)
A check must be used – if any other slip or form is inserted the printer will not
conduct.
Extended Slip
Table
The check then goes through the flip routine only – no printing takes place.
The printer is in Normal Mode and can communicate with the host computer.
Configuring the Printer," for instructions on how to enter the Configuration Menu.
LED
Guide
November 2002
Chapter 4: Diagnostics
63