Using The Printer - NCR 7167 Owner's Manual

7167 Owner's Manual

Using the Printer

Note: See "Setting Switches" earlier in this book for instructions on setting the DIP
switches.
1. Connect the power supply cable to the printer and turn on the power source.
The printer goes through a self-test routine to ensure everything is working
properly then "beeps." After the printer has completed its "startup" cycle, it is
ready to receive data.
If the LED blinks, or the host computer indicates that there is a problem, see
"Chapter 3: Solving Problems" for more information.
2. To perform a Configuration check (optional), reset the printer while holding the
Paper Feed Button, or open the receipt door and while pressing the paper feed
button close the receipt door, let go of the Paper Feed Button once the printing
begins.
Note: The printer receives power when the power supply is on even if the printer is
off-line. To completely remove power, unplug the power supply from the outlet, or
turn the POS terminal off.
Chapter 2: Setting Up and Using the Printer
LED
Paper Feed
Button
November 2002 39