NCR 7167 Owner's Manual page 32

7167 Owner's Manual
6. Select RS232/USB.
7. Skip through the parameters with short clicks until Set Flow Control Method is
displayed.
8. Follow the instructions to select either XON/OFF or DTR/DSR, then skip the
remaining communications parameters.
9. When you have finished, set DIP switch 1 to Off (down).
10. Reset the printer.
The printer resets with the new selection. You can verify the new setting by pressing
the Paper Feed button to print out a diagnostics form or by holding the Paper Feed
button while closing the Receipt Cover.
22
Chapter 2: Setting Up and Using the Printer
November 2002