NCR 7167 Owner's Manual page 230

7167 Owner's Manual
m
(Hex)
38
40
50
Set the printer configuration specified by m and n. The printer is reset after receiving this
command to activate the configuration setting. If m or n is out of range, this command is
ignored. The printer will wait for the data until the terminator code "0FFH" is received.
Example:
The following command would set the communication baud rate to 115,200 bps.
MSComm1.Output = Chr$(&H1F) & Chr$(&H11) & Chr$(&H11) & Chr$(&H0) & Chr$(&HFF)
208
Function
MICR dual pass option
Default Code page
EEPROM default setting
n Function
(Hex)
00 Dual pass disable
01 Dual pass enable
00 437
01 850
02 852
03 858
04 860
05 862
06 863
07 864
08 865
09 866
0A 874
0B 1252
0C Katakana
0D 932 (or 936, 949, 950)
00 EEPROM default setting
November 2002
Chapter 6: Commands