Connecting The Cables - NCR 7167 Owner's Manual

7167 Owner's Manual
Switch 1 Settings
OFF (0)
ON (1)
OFF (0)
ON (1)
•
It is optional to set this switch to ON when reflashing the IPL firmware.

Connecting the Cables

There are three different types of cables that connect to the printer:
•
Power supply cable supplying power from the host POS terminal or from a
external power supply
•
Communication cable (RS-232 or USB) connecting the printer to the host computer
•
Cash drawer cable connecting the printer to one or two cash drawers
Caution: Disconnect the power before connecting the cables. Always connect the
communication cable and cash drawer cables before connecting power to the power
source. Always disconnect power to the power source before disconnecting the
communication and cash drawer cables.
Follow these steps to connect the cables. See the illustration on the next page.
1. Unplug the power cable from its power source.
2. Connect the power and communication cables to their respective connectors
under the printer as shown in the illustration.
For RS232 cable, be sure to screw the communication cable to the communication
connector.
3. Route the cables through the cable strain relief on the bottom of the printer, then
through the two slots in the cable access cover as shown in the illustration.
4. Connect the communication cable to the appropriate host computer connector.
5. Connect the cash drawer cable to the printer and cash drawer.
The connectors is a standard phone jack located at the rear of the printer.
14
Switch 2 Settings Printer State
OFF (0) On-line Mode (default)
OFF (0) Diagnostic Mode
ON (1) * Flash Download Mode
ON (1) Vendor Adjustment Mode
Chapter 2: Setting Up and Using the Printer
November 2002