NCR 7167 Owner's Manual page 25

7167 Owner's Manual
6. For Host powered installation plug the DC cable into the POS terminal or plug the
power cord into the power supply for remote power supply installation, then plug
the power supply into an outlet.
At this point, the printer receives power. If the On Line LED (green) is on, the printer
is on-line. Otherwise, the printer is not receiving power. Check to insure that the host
terminal is on or that the power supply is on.
USB Cable
RS-232 Cable Connection
Communication Power
Connector Connector
Power
Communication
Cable
Cable
USB Cable Connection
Power
USB
Connector
Connector
Power Cable
Chapter 2: Setting Up and Using the Printer
DIP Switch
Cash Drawer Cash Drawer
Cable Connector
DIP Switch Cash Drawer Cash Drawer
Cable Connector
November 2002 15