NCR 7167 Owner's Manual page 74

7167 Owner's Manual
Datascope Mode
Datascope Mode allows the user to test the printer's communications. When in Datascope
Mode the printer receives all communications, but instead of executing the commands it
prints them out on receipt paper as hexadecimal numbers in the order received. For
example, the ASCII character "A" is printed as the hexadecimal number 41 an so on.
To run the Datascope Mode:
1. Enter the Configuration Menu. See "Configuring the Printer" for instruction on how to
2. After you have enabled the Datascope Mode through the Configuration Menu, exit the
3. Run a transaction from the host computer.
30 31 32 33 34 35 36 37 38 39 40 41
41 42 43 44 45 46 47 48 49 50 51 52
To exit the Datascope Mode:
1. Enter the Configuration Menu again
2. Disable the Datascope Mode
3. Exit the Configuration Menu
The printer is in Normal Mode and can communicate with the host computer.
Slip Test Mode
To run the Slip Test Mode:
1. Enable the Slip Test Mode through the Configuration Menu, (See "Configuring the
2. Insert a slip into the slip station.
3. Push the Paper Feed Button
4. All code pages will be printed.
5. Go to step 2 again to repeat this test.
To exit the Slip Test Mode:
1. Enter the Configuration Menu again.
2. Disable the Slip Test Mode.
MICR Test mode
Check Flip Test mode
Print Head Test Mode
Enter code, then hold Button DOWN
At least 1 second to validate
enter the Configuration Menu.
Configuration Menu.
All commands and data sent from the host computer will be printed as hexadecimal
numbers as shown in the illustration.
Printer," for instructions on how to enter Configuration Menu). Then exit the
Configuration Menu.
-> 1 Click
-> 2 Clicks
-> 3 Clicks
November 2002
Chapter 4: Diagnostics
: 0 1 2 3 4 5 6 7 8 9 @ A
: A B C D E F G H I J K L
61