NCR 7167 Owner's Manual page 122

7167 Owner's Manual
Set Slip Paper Waiting Time
Hexadecimal:
Sets the time (in m minutes) that the printer waits for a slip to be inserted into the slip
station. It also sets the time (n x 0.1 seconds) that the printer waits to close the platen and
start printing once the slip has been inserted. The printer reads that a slip is inserted when
the leading edge and trailing edge sensors are covered. The LED on the slip table is lit
(green) when both sensors are covered.
If a slip is not inserted in the time specified, the receipt station is selected for the next
function. If m = 0, the printer waits forever for a slip to be inserted. The times set by this
command are used only by the command, Select Receipt or Slip for Printing, Slip for MICR
Read (1B 63 30 n), with n set to 04.
Example:
MSComm1.Output = Chr$(&H1B) & Chr$(&H66) & Chr$(m) & Chr$(n)
100
ASCII: ESC f m n
1B 66 m n
Decimal: 27 102 m n
Value of m : Minutes
Value of n : Tenths of seconds
November 2002
Chapter 6: Commands