NCR 7167 Owner's Manual page 147

7167 Owner's Manual
Set Character Right-Side Spacing
Sets the right side character spacing to [n x horizontal or vertical motion units]. Values for
this command are set independently in Standard and Page Mode.
The units of horizontal and vertical motion are specified by the Set Horizontal and Vertical
Minimum Motion Units (1D 50...) command. Changes in the horizontal or vertical units
do not affect the current right side character spacing. When the horizontal or vertical
motion unit is changed by the Set Horizontal and Vertical Minimum Motion Units (1D
50...) command the value must be in even units and not less than the minimum amount of
horizontal movement.
In Standard Mode the horizontal motion unit is used.
In Page Mode the horizontal or vertical motion unit differs and depends on the starting
position of the printable area. When the starting printing position is the upper left or lower
right of the printable area (set by Select Print Direction in Page Mode, 1B 54 n) the
horizontal motion unit (x) is used. When the starting printing position is the upper right or
lower left of the printable area (set by Select Print Direction in Page Mode, 1B 54 n) the
vertical motion unit (y) is used.
Example:
MSComm1.Output = Chr$(&H1B) & Chr$(&H20) & Chr$(n)
Exception:
This command is ignored in 7156 Emulation Mode and is only valid on the receipt station.
ASCII: ESC SP n
Hexadecimal: 1B 20 n
Decimal: 27 32 n
Range of n: 0 - 32
Default: 0
November 2002
Chapter 6: Commands
125