NCR 7167 Owner's Manual page 70

7167 Owner's Manual
*** Diagnostics Form ***
Model number : 7167
Serial number : A991703053
Boot Firmware
Revision V00.17
:
CRC : C525
Flash Firmware
Revision : V03.12
CRC : 0EFF
Hardware
Flash Memory Size : 2Mbytes
Flash Logos Size : 256Kbytes
Flash Fonts Size : 64Kbytes
Flash User Storage : 64Kbytes
Communication Interface
Interface Type : RS232/USB
Parameters
Baud Rate : 9600
Data Bits : 8
Stop Bits : 1
Parity : None
Flow Control : DTR/DSR
Reception Errors : Print '?'
Receive Buffer : 4K Bytes
Diagnostic Mode : OFF, Normal Mode
Emulation/Software
Printer Emulation : 7158 Native Mode
Printer ID Mode : 7158 Native ID
Default LPI : 7.52
To enter Diagnostics Mode:
1) Flip DIP switch #1 on
2) Reset the printer by pressing
and holding the Receipt Feed switch
down while disconnecting and
reconnecting the power.
Configuration Menu and Print Test samples (show approximately 60% of size).
*** Printer Config Menu ***
The config menu allows you to set
general printer parameters. Sub-menus
are entered and selections are made
using the Paper Feed Button:
- Short Click : Feed Button is
Long Click : Feed Button is held
-
CAUTION !!
The settings are predetermined in
factory and should generally not be
changed to avoid changing other
functions.
**************
************* Main Menu *************
*****************************************
Select a sub –menu:
- EXIT
- Print Current Configuration
- Set Communication Interface
- Set Diagnostics Modes
- Set Emulation/Software
- Set Hardware Options
- Set Default Code Page 7 Clicks
Set EEPROM To Default
Enter code, then hold Button DOWM
at least 1 second to validate
Important: Ensure that the
configuration settings match
your host computer, if not,
enter the Configuration Menu
to make changes.
November 2002
Chapter 4: Diagnostics
quickly depressed
then released.
Down more than 1sec
then released.
1 Click
2 Clicks
3 Clicks
4 Clicks
5 Clicks
6 Clicks
8 Clicks
57