NCR 7167 Owner's Manual page 125

7167 Owner's Manual
m
0, 48
1, 49
65
66
Range of m:
Range of n:
Default of n:
Default of m:
Selects a mode for cutting paper and cuts the paper. There are two formats for this
command, one requiring one parameter m, the other requiring two parameters, m and n.
The format is indicated by the parameter m.
Formulas: n times the vertical motion unit is used to determine the cutting position to the
distance that the paper is fed.
Example:
MSComm1.Output = Chr$(&H1D) & Chr$(&H56) & Chr$(m) & Chr$(n)
Exceptions:
If m is out of the specified range, the command is ignored.
Feed and Cut Mode
Full cut (no extra feed). Partial cut on the 7158/7167.
Partial cut (no extra feed).
Feeds paper to cutting position + (n times vertical motion unit),
and cuts the paper completely.
Feeds paper to cutting position + (n times vertical motion unit),
and performs a partial cut.
0, 48; 1, 49
65, 66 (when used with n)
0 - 255
0
0
November 2002
Chapter 6: Commands
103