NCR 7167 Owner's Manual page 31

7167 Owner's Manual
*** Diagnostics Form ***
Model number
Serial number
Boot Firmware
Revision
CRC
Flash Firmware
Revision
CRC
Hardware
Flash Memory Size
Flash Logos Size
Flash Fonts Size
Flash User Storage
Communication Interface
Interface Type
Parameters
Baud Rate
Data Bits
Stop Bits
Parity
Flow Control
Reception Errors
Receive Buffer
Diagnostic Mode
Emulation/Software
Printer Emulation
Printer ID Mode
Default LPI
To enter Diagnostics Mode:
1)
2)
Follow the instructions on the scrolling menu, pressing the Paper Feed button to make
selections. Indicate Yes with a long click, and No with a short click.
•
Press and hold the Paper Feed button for at least one second for a long click.
•
Press the Paper Feed button quickly for a short click.
5. Select Set Communication Interface from the Main Menu.
: 7167
: A991703053
: V0.17
: C525
: V03.12
: 0EFF
: 2Mbytes
: 256Kbytes
: 64Kbytes
: 64Kbytes
: RS232/USB
: 9600
: 8
: 1
: None
: DTR/DSR
: Print '?'
: 4K Bytes
: Off, Normal Mode
: 7158 Native Mode
: 7167 Native ID
: 7.52
Flip DIP switch #1 on
Reset the printer by pressing
and holding the Receipt Feed switch
down while disconnecting and
reconnecting the power.
The printer scrolls to the first menu selections.
Chapter 2: Setting Up and Using the Printer
*** Printer Config Menu ***
The config menu allows you to set
general printer parameters. Sub-menus
are entered and selections are made
using the Paper Feed Button:
- Short Click : Feed Button is
quickly depressed
then released.
- Long Click : Feed Button is held
Down more than 1sec
then released.
CAUTION !!
The settings are predetermined in
factory and should generally not be
changed to avoid changing other
functions.
**************
************* Main Menu *************
*****************************************
Select a sub –menu:
- EXIT
- Print Current Configuration
- Set Communication Interface
- Set Diagnostics Modes
- Set Emulation/Software
- Set Hardware Options
- Set Default Code Page 7 Clicks
Set EEPROM To Default
Enter code, then hold Button DOWM
at least 1 second to validate
Important: Ensure that the
configuration settings match
your host computer, if not,
enter the Configuration Menu
to make changes.
November 2002
1 Click
2 Clicks
3 Clicks
4 Clicks
5 Clicks
6 Clicks
8 Clicks
21