Slip Or Forms Printing Is Light - NCR 7167 Owner's Manual

7167 Owner's Manual
AC supply voltage is out of
range
Thermal print head temperature
is out of range
Power supply voltage is out of
range

Slip or Forms Printing is Light

Problem
Ribbon cassette is worn
49
If paper is not low and no conditions indicate
that the thermal print head is too hot, then it is
likely that the power supply voltage is out of
range.
Contact a service representative if this does
not resolve the problem.
The print head may overheat when printing in
a room where the temperature is above the
recommended operating temperature or when
printing high-density graphics continuously,
regardless of the room temperature. In either
case, the printer will shut off.
If the temperature of the print head is too hot,
adjust the room temperature or move the
printer to a cooler location.
If the print head is overheating because of
printing high density graphics continuously,
reduce the demand on the printer.
If the printer continues to overheat, contact a
service representative.
If paper is not low and no conditions indicate
that the print head is too hot, the power
supply voltage is out of range. Contact a
service representative.
What to Do
Replace the ribbon cassette.
Contact a service representative if this does
not resolve the problem.
See "Contacting a Service
Representative" later in
this chapter.
See "Environmental
Conditions" in Appendix
A for the recommended
temperature range for
operating the printer.
See "Contacting a Service
Representative" later in
this chapter.
See "Contacting a Service
Representative" later in
this chapter.
Where to Go
See "Putting In and
Changing the Ribbon
Cassette" in chapter 2.
See "Contacting a Service
Representative" later in
this chapter.
November 2002
Chapter 3: Solving Problems