Slip Form Parameters - NCR 7167 Owner's Manual

7167 Owner's Manual

Slip Form Parameters

In order for the printer to handle forms properly the forms shall be flat and void of curls or wrinkles
especially at the leading edge of the form.
Form construction for glued edges.
The sensors on the printer slip station use a reflective type photo sensor. Therefore the following
precautions must be taken to allow for proper operation.
1
1) Bottom edge of form should not be glued
2) Paper feeding and insertion are affected by gluing method and the quality of glue used
when form is glued on the right or top edge of form.
3) Skewing may occur when the form is glued on the left edge or when a wide form is used.
•
Paper that has holes or is translucent in the sensor locations as shown below should not be
used.
•
When thin paper is used it should be placed between the top and bottom sheets of multi-
ply paper. The thickest ply of paper should be the last ply
Glued Location
2 2
November 2002
Appendix B: Print Characteristics
Paper Feed Direction
3
223