Being Called By The Remote Station (Standby Operation) - Yaesu FT2DR Operating Instructions Manual

Calling Only a Specific Station
3
Touch [SIGNALING].
4
Touch [6 New Pager Function].
5
Rotate the DIAL to select [CODE-TX], then press the
6
Rotate the DIAL to select the first element of the code used by the remote station, then
press the
Caution Register the pager code of the remote station in advance.
The cursor moves.
7
Rotate the DIAL to select the second element of the code used by the remote station,
then press the
8
Press .
The code is set and the transceiver exits from Set mode.
9
Press .
The remote station is called.

Being Called by the Remote Station (Standby Operation)

If you turn on the Bell Function (
remote station by the [PAG] display, the blinking [ ] icon, and the Bell sound. Also, if you
turn on the vibrator function (
been called by the remote station.
Tip
Pressing and holding the
New Pager Function] → [ANS-BACK] → [ON] in Set mode, automatically places the transceiver in
transmission mode (for about 2.5 seconds) when called by the remote party, and notifies the remote
party that you are ready to communicate.
118
New Pager Function
key.
key.
see page 114), you are alerted to a call from the
see page 113), the vibrator can alert you that you have
When called
key for over one second, and then selecting [SIGNALING] → [6
key.
Blinks