Set Mode: Scan Menu Operations; Setting The Surveillance Interval Time For Priority Channels Dw Interval Time Function; Setting The Illumination On/Off When Scanning Stops Lamp Function; Setting The Time To Resume Scanning Scan Re-Start Function - Yaesu FT2DR Operating Instructions Manual

Set Mode: SCAN Menu Operations

Press and hold the
[SCAN] to set the individual items.
After completing the setup, press
Setting the Surveillance Interval Time for Priority Channels
DW INTERVAL TIME Function
When the dual receive function is active, the interval time at which the priority channel is
monitored can be set.
1
Rotate the DIAL, then touch [1 DW TIME].
2
Rotate the DIAL to select the monitoring interval from 0.1 SEC to 10 SEC.
Remark The default setting: 5.0 seconds
Setting the Illumination On/Off When Scanning Stops
LAMP Function
Set whether or not the LCD backlight is turned on when a signal is received during
scanning.
1
Rotate the DIAL, then touch [2 SCAN LAMP].
2
Rotate the DIAL to select the desired setting.
ON The LCD backlight will illuminate when a signal is received.
OFF The LCD backlight will not illuminate when a signal is received.
Remark The default setting: ON
Setting the Time to Resume Scanning
SCAN RE-START Function
Set the time interval to resuming scanning after a received signal ends during scanning.
1
Rotate the DIAL, then touch [3 SCAN RE-START].
2
Rotate the DIAL to select the time to resume scanning from 0.1 SEC to 10 SEC.
Remark The default setting: 2.0 seconds
142
key for over one second to display "SETUP MENU", then touch
to exit from Set mode.