Setting The Receive Operation When The Scanning Stops - Yaesu FTM-400DR Operating Manual

● To stop the scanning
To stop the scanning, either touch [SCAN] or press the microphone [PTT] button (the
radio will not transmit in this case).
Setting the receive operation when the scanning stops
Any of the following three methods can be selected as the action to be taken after the
scanning stops.
(1) Restarts the scanning after receiving for the set amount of time. Select from one,
three or five seconds.
(2) Continues receiving until the signal disappears and then restart the scanning two
seconds after the signal disappears (BUSY).
(3) Stops the scanning to receive at that frequency (HOLD).
1
Press for one second or longer
The set-up menu will be displayed.
2
Touch [SCAN]
The menu list will be displayed.
3
Touch [3 SCAN RESUME] to select the reception
method
The reception method will change in the following
order each time the screen is touched.
"BUSY" → "HOLD" → "1sec" → "3sec" → "5sec"
Tips • The reception method can also be selected by pressing
.
• Factory default value: 3 sec
4
Press for one second or longer
The reception method when the scanning stops will be set and the display will return
to the previous screen.
Tip
The settings here are applicable to "VFO Scan", "Memory Scan" and "Programmable Memory Scan".
Signal Search
73