Program 50-6 - Lcr Dial 0 (Zero) Time-Out - Toshiba DK14 Programming Manual

Program 50-6 – LCR Dial 0 (Zero) Time-out
Processor Type:
Program Type:
Initialized Default:
✱ ✱ ✱ ✱
Program 50-6 Overview
Enter the maximum number of seconds LCR waits for a user to dial additional digits after a 0,
before it routes the call to an operator for assistance. LCR waits this number of seconds to receive
additional digits that indicate charge calls, collect calls or other 0+ calls.
o The allowed range is 04~10 seconds. Always enter two digits.
o Dial 0 calls will be restricted when using 0 + Credit Card calling (Program 43) if a telephone
number is not dialed after dialing 0 or if Dial 0 is restricted in Program 46 (10~80).
Overview for Programs 51~54
These programs provide the system with directions for routing all possible calls, made by all
possible users at all possible times of day. Tables for Programs 51~54 appear on LCR Route Plan
Numbers 1~16. The following instructions show how to fill in individual tables within the plans.
Each of the following program tables must be completed for all plans.
Programs 51~54 defines LCR route plans (quantities given below):
Processor
DK14
DK40i
RCTUA
These separate plans provide the customer flexibility enough to route different area codes and
exception office codes over different line groups.
Strata DK Programming 5/00
DK14, DK40i, all RCTUs and BCUs
Least Cost Routing
Assigns an LCR Dial Zero Time-out value of 06
SELECT = 6 DATA = Time-out Value
Enter a time-out value from 04~10 seconds long.
LCR Route
Plans
8
8 RCTUC/D, B2CAU/BU, B3CAU/BU
8
Program 50-2 – LCR Home Area Code
LCR Route
Processor
Plans
RCTUBA/BB, B1CU
16
RCTUE/F, B5CAU/BU 16
Least Cost Routing
8
5-9