Toshiba DK14 Programming Manual page 261

In the "Data = Digit String" part of the programming sequence, note that for two digit codes, such
as 87, 82, 67, Key (LED Button 01) must be pressed to get to the following "Option=" section. For
✱
example, enter
The Privacy Change option (0~4) enables the telephone user to override the setting for their own
telephone. For instance, if Privacy Change is enabled, then a user can press
Caller ID to be shown on the caller's LCD.
Example 1
If using LCR behind Centrex and you must dial Centrex speed dial numbers
+
+
applied after the Centrex speed dial number (
set.
Example 2
If you are dialing out and you wish to block the Caller ID feature, you must dial
appropriate provider's code (e.g.,
*45-31. In this case, if the user dials
applied to the telephone number after
override Privacy Change, for the fourth entry, Option "4", enter a .
In this case, enter
telephone number, then Toll Restriction and LCR is applied to the telephone number after
dialed because Option "4" is set.
✱
To allow or to be entered as a first digit, a number must be entered in at least one table of
Program 45-3X; do not enter
Restriction assumes the number entered in this table begins with a
Important! To allow
Program *45-3X.
✱
Using or # as the First Digit on ISDN BRI/PRI
✱
In order to use or as the first digit on ISDN BRI/PRI, you need to enter the following in the
Program *45-3 programming sequence:
Strata DK Programming 5/00
Program *45-3 (1~9) – LCR/Toll Restriction Bypass For Special Numbers that Begin with */#
( _ = Press LED Button 01) +
+ in Program *45-31. In this case, Toll Restriction will not be
✱
✱ ✱
, ). In this case, enter
✱
+ telephone number, then Toll Restriction and LCR is
✱
is dialed because Option "3" is set. Also, if you want to
+ + + in Table *45-31. In this case, if the user dials
✱
and as the first digit of any number in Program *45-3X; Toll
✱ / to be dialed as a first digit, at least one number must be entered in
SELECT =
DATA =
(1~9)
Press LED 02
1 twice, then press
LED 01 once
.
) is sent to the Centrex because Option "0" is
+ +
✱
or .
OPTION = OPTION =
0 0
Toll Restriction
✱
to allow their
✱ ✱
~ , enter
✱
or the
+ in Table
✱
+
✱
is
4-27